BannerFans.com

Tuesday, November 8, 2011

How to repair clutch hydraulic system for 2003 ford focus


Hydraulic System


Hydraulic System Bleeding



  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Air cleaner assembly
    Mass Air Flow (MAF) sensor connector
    Air intake pipe
  3. Remove fluid from the brake fluid reservoir until the level reaches the MINmark.
  4. Fill the reservoir of Special Tool 416-D002 with DOT 4 brake fluid.
  5. Attach the tool to the slave cylinder bleed nipple.
  6. Open the bleed nipple and pump 80 ml brake fluid into the clutch control system.
  7. Tighten the bleed nipple to 88 inch lbs. (10 Nm) and remove the tool.
  8. Have an assistant depress the clutch pedal 4-5 times and hold the pedal at full travel.
  9. Close the bleeder before releasing the clutch pedal.
  10. Repeat the procedure until no more air bubbles are seen.
  11. Check the clutch for proper operation.
  12. Check the brake fluid reservoir level and fill with DOT 4 brake fluid, as necessary.
  13. Install or connect the following:

    Air intake pipe
    MAF sensor connector
    Air cleaner assembly

-----------------------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------



 

No comments:

Post a Comment