How to replace clutch slave cylinder for 2003 ford focus

Slave Cylinder

Removal & Installation

NOTE

These vehicles use a hydraulic throwout bearing instead of a traditional clutch release slave cylinder. Accessing this part requires removal of the transaxle.

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
3. Remove the transaxle.
4. Remove the clutch slave cylinder.
   
   
   

   

   Fig. Clutch slave cylinder/hydraulic throwout bearing-internal view.

To install:

1. Coat the input shaft splines with high-temperature grease.
2. Install the clutch slave cylinder and tighten the bolts to 89 inch lbs. (10 Nm)
3. Install the transaxle.
4. Fill and bleed the clutch system.

------------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-start.html

-----------------

Car will not crank?

http://schematicsdiagram.blogspot.com/2011/06/car-will-not-crank.html

-----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

-------------

How to troubleshoot car battery?

http://schematicsdiagram.blogspot.com/2011/06/how-to-troubleshoot-car-battery.html

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------

car will turn over but will not start?

http://technoanswers.blogspot.com/2011/05/car-will-turn-over-but-will-not-start.html

-----------------

Car wont start?

http://howtobyme.blogspot.com/2011/10/car-wont-start.html

----------