Friday, April 6, 2012

How to replace Blower motor on Chevrolet Aveo?

In this chapter details are mentioned to replace Blower motor.

The procedure is as follows:----

Blower Motor
Removal & Installation

  1. Disconnect the negative battery cable.
  2. Disconnect the blower motor electrical connector.
  3. Remove the blower cooling hose.
  4. Remove the screws that secure the motor to the heater/air distribution case.
  5. Remove the motor and the seal from the heater/air distribution case by gently pulling the motor straight down and out. 

    Fig. Location of the blower motor
To install:
  1. Install the blower motor and seal, with the shock mount pads, in the heater/air distribution case. Hold the blower motor in position.
  2. Install the screws to secure the blower motor to the heater/air distribution case.
  3. Tighten the blower motor retaining screws to 53 inch lbs. (6 Nm).
  4. Install the blower motor cooling hose.
  5. Connect the electrical connector.
  6. Connect the negative battery cable.
  7. Confirm that the blower motor operates properly.

These details will help.


Car repair guide?

No comments:

Post a Comment