BannerFans.com

Monday, April 23, 2012

2.5L Engines Cylinder Head Cover?

The Procedure to replace Valve Cover.
The details for 2.5L Engine models.

Please Note that this Procedure Covers all U.S. and Canadian models of the Chrysler/Dodge Avenger, Chrysler Sebring Coupe and Dodge Stratus/ Stratus Coupe models for Year 1999 to 2005.

The Procedure for Front & Rear Head Cover:--

2.5L Engines
Front Cylinder Head Cover
  1. Disconnect battery negative cable from remote negative terminal on shock tower and properly isolate to prevent accidental reconnection.
  2. Disconnect and relocate spark plug cables and wiring harness.
  3. Disconnect PCV and breather hoses.
  4. Remove cylinder head cover fasteners and remove cover.
To install:
  1. Clean cylinder head and cover mating surfaces. Install new gasket.
  2. Install cover and tighten cover bolt washer and gasket assembly to 88 inch lbs. (10 Nm)
  3. Connect PCV and breather hoses.
  4. Connect spark plug cables and wiring harness.

NOTE
The spark plug tube seals are located on the end of each tube. These seals slide onto each tube to seal the cylinder head cover to spark plug tube. Replace seals if hardened or cracked.

Rear Cylinder Head Cover
  1. Remove upper intake manifold. Refer to procedure in intake manifold section.
    NOTE
    Cover lower intake manifold with a suitable cover during service.
  2. Disconnect and relocate spark plug cables.
  3. Disconnect breather hose.
  4. Remove cylinder head cover fasteners and remove cover.
To install:
  1. Clean cylinder head and cover mating surfaces. Install new gasket.
  2. Install cover and tighten cover bolt washer and gasket assembly to 88 inch lbs. (10 Nm)
  3. Connect spark plug cables.
  4. Connect breather hose.
  5. Install upper intake manifold. Refer to intake manifold section.


Recommend and Related Help solutions :---

3.0L Intake manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/intake-manifold-replacing-on-avenger.html

2.7L Intake manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/intake-manifold-replacing-on-avenger.html

2.5L Intake Manifold replacing on Avenger, Stratus and Sebring?

http://fordrepairhelp.blogspot.in/2012/04/25l-intake-manifold-replacing.html

Dodge and Chrysler 2.5L Intake Manifold replacing?

Dodge Stratus, Avenger and Chrysler Sebring 2.0L Intake manifold Replacing Procedure?

http://fordrepairhelp.blogspot.in/2012/04/dodge-stratus-avenger-and-chrysler.html

These details will help.
Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment