3.0L Engine Removal for dodge and Chrysler?

The details mentioned here in this chapter are for Dodge Caravan and Chrysler Town and Country Car models.

The step by step instructions to replace Engine is as follows:----

3.0L Engines:----

1. Drain the cooling system.
2. Drain the engine oil.
3. Relieve the fuel system pressure.
4. Remove or disconnect the following:
   
   
   Battery and tray

   Air cleaner and hoses

   Heater hoses

   Engine cooling fan

   Radiator

   Transaxle shift linkage

   Throttle body linkage and vacuum lines

   Accessory drive belts

   Alternator

   A/C compressor

   Axle halfshafts

   Left and right inner splash shields

   Exhaust front pipe

   Front motor mount and bracket

   Rear transaxle mount and bracket

   Power steering pump and bracket

   Engine wiring harness

   Bending braces

   Torque converter

   Body ground straps
5. Support the powertrain from below.
6. Remove the right motor mount and the left transaxle mount through bolt.
7. Raise the vehicle away from the powertrain.

To install:

1. Lower the vehicle over the powertrain.
2. Install or connect the following:
   
   
   Right motor mount. Tighten the frame rail bolts to 50 ft. lbs. (68 Nm), the vertical fastener to 75 ft. lbs. (102 Nm) and the horizontal fastener to 111 ft. lbs. (150 Nm).

   Left transaxle mount through bolt. Tighten the bolt to 55 ft. lbs. (75 Nm).

   Body ground straps

   Torque converter. Tighten the bolts to 50 ft. lbs. (68 Nm).

   Bending braces

   Engine wiring harness

   Power steering pump and bracket

   Rear transaxle mount and bracket. Tighten the bolts to 45 ft. lbs. (61 Nm).

   Front motor mount and bracket. Tighten the large bracket bolts to 80 ft. lbs. (108 Nm), the small bracket bolts to 40 ft. lbs. (54 Nm) and the through bolt to 45 ft. lbs. (61 Nm).

   Exhaust front pipe

   Left and right inner splash shields

   Axle halfshafts

   A/C compressor

   Alternator

   Accessory drive belts

   Throttle body linkage and vacuum lines

   Transaxle shift linkage

   Radiator

   Engine cooling fan

   Heater hoses

   Air cleaner and hoses

   Battery and tray
3. Fill the cooling system.
4. Fill the engine with clean oil.
5. Start the engine, check for leaks and repair if necessary.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html