Bleeding Power steering Pump on Ford E series?

Power Steering Pump Bleeding for Ford E series Vans is as follows:-----

Bleeding: ----


Specific to:

Ford E-150 2008-2009

Ford E-250 2008-2009

Ford E-350 Super Duty 2008-2009

Remove the power steering pump reservoir cap. Check the fluid.
Raise the front wheels off the floor.
Tightly insert the stopper of the vacuum pump into the reservoir.
Start the engine.
Install the vacuum pump, apply vacuum, and maintain the maximum vacuum of 68-85 kPa (20-25 in-Hg).
If equipped with Hydro-Boost®, apply the brake pedal twice.
CAUTION
Do not hold the steering wheel against the stops for more than 3 to 5 seconds at a time. Damage to the power steering pump can occur.

Cycle the steering wheel fully from stop-to-stop 10 times.
Stop the engine.
Release the vacuum and remove the vacuum pump.
Fill the reservoir.
Start the engine.
Install the vacuum pump. Apply and maintain the maximum vacuum of 68-85 kPa (20-25 in-Hg).
Cycle the steering wheel fully from stop-to-stop 10 times.
Stop the engine, release the vacuum and remove the vacuum pump.
Fill the reservoir as needed and install the reservoir cap.
Visually inspect the power steering system for leaks.
Install the reservoir cap.

This details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html