Ford Focus Component location?

See all the component location diagram for ford focus.
The location diagram consists of parts:----


Camshaft Position Sensor,Crankshaft Position Sensor,Cylinder Head Temperature Sensor
,Fuel Rail Pressure & Temperature Sensor,Heated Oxygen Sensor,Idle Air Control Valve,Knock Sensor,Mass Airflow Sensor,Powertrain Control Module.

Camshaft Position Sensor:--

Crankshaft Position Sensor

Cylinder Head Temperature Sensor

Showing the CHT sensor configuration

Fuel Rail Pressure & Temperature Sensor

The fuel rail pressure and temperature sensor is mounted on the fuel rail. 

Heated Oxygen Sensor:

The oxygen sensors are located in the exhaust pipe, before and after the catalytic converter. 

Idle Air Control Valve:

The idle air control valve is located on the throttle body assembly, under the snow shield.

Knock Sensor:

The knock sensor is located on the side of the cylinder head.

Mass Airflow Sensor

The MAF sensor is located on the inlet tube of the intake air system.

Powertrain Control Module:

The PCM is located behind the cowl trim (kick panel) on the passenger side of the vehicle.

This will help.

Thanks.

See below latest solved car problems :---

How to replace Drive Shaft bearing on Toyota pick up?

http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-drive-shaft-bearing-on.html

Car suddenly died and won’t start?

http://technoanswers.blogspot.in/2012/02/car-suddenly-died-and-wont-start.html

Car is starting but not turning over?

http://technoanswers.blogspot.in/2012/02/car-is-starting-but-not-turning-over.html

Engine cranks but will not start?

http://technoanswers.blogspot.in/2012/02/engine-cranks-but-will-not-start.html

Exclamation indicator light on ford freestar dash?

http://technoanswers.blogspot.in/2012/02/exclamation-indicator-light-on-ford.html

2004 ford freestar van idles rough?

http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html

How to remove Intake Manifold Tuning Valve?

http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html

Trunk release Problem on Toyota Camry?

http://schematicsdiagram.blogspot.in/2012/02/trunk-release-problem-on-toyota-camry.html

CMFI details for GMC vehicles?

http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html

Mazda MPV cranks but will not start?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-cranks-but-will-not-start.html

MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html

Freightliner fl112 fuse box diagram?

http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

Car only starts when gas pedal is pressed?

http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html

How to compare pattern of left bank and right bank sensors?

http://schematicsdiagram.blogspot.in/2012/02/how-to-compare-pattern-of-left-bank-and.html