The details to replace AC Compressor on Ford E series Vans is as follows:----
Removal & Installation
4.6L, 5.4L & 6.8L ENGINES
6.0L ENGINE
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
Removal & Installation
4.6L, 5.4L & 6.8L ENGINES
6.0L ENGINE
4.6L, 5.4L & 6.8L Engines
Specific to:
Ford E-150 2008-2009
Ford E-250 2008-2009
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Raise and safely support the vehicle.
- Properly recover the A/C refrigerant.
- Remove the lower engine splash shield, if equipped.
- Remove the accessory drive belt from the A/C compressor pulley.
- Disconnect the Crankshaft Position (CKP) sensor electrical connector.
- Disconnect the clutch field coil electrical connector and position the wire harness aside.
- Completely loosen the A/C compressor bolts and position the A/C compressor to allow access to the fitting nuts.
- Remove the A/C compressor fitting nuts and disconnect the fittings.
- Installation is the reverse order of removal. Tighten the A/C compressor mounting bolts to 18 ft. lbs. (25 Nm).
6.0L Engine
Specific to:
Ford E-350 Super Duty 2008-2009
- Before servicing the vehicle, refer to the Precautions Section.
- Raise and safely support the vehicle.
- Properly recover the A/C refrigerant.
- Remove the accessory drive belt from the A/C compressor pulley.
- Remove the wiring harness stud.
- Remove the A/C compressor mounting bolts.
- Disconnect the clutch field coil electrical connector.
- Remove the right hand front wheel.
- Loosen the compressor manifold bolt and detach the compressor manifold and tube assembly. Discard the O-ring seals.
- Remove the A/C compressor.
- Installation is the reverse order of removal. Tighten the A/C compressor mounting bolts to 18 ft. lbs. (25 Nm).
This will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment