BannerFans.com

Tuesday, March 13, 2012

Replacing Blower Motor on Ford E series vans?

The details to replace Blower motor on Ford E series Vans is as follows:---


Blower Motor
REMOVAL & INSTALLATION
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the rear seats to access the LH rear quarter trim panel.
  3. Remove the body side trim finish panel.
  4. Disconnect the powerpoint electrical connector, if equipped.
  5. Pry the rear seat shoulder strap covers from the upper trim panels.
  6. Pull the rear door weatherstrip off at the rear door opening to access the trim panel pin-type retainers.
  7. Remove the rear upper quarter trim panel and lower quarter trim panel.
  8. Remove the window latches.
  9. Disconnect the blower motor electrical connector.
  10. Remove the blower motor vent tube.
  11. Remove the blower motor screws.
  12. Remove the blower motor.
  13. Installation is the reverse order of removal. 

    image
    Fig. Electrical Connector (1), Housing Tube (2), Mounting Screws (3), Blower Motor (4)-E-Series Models
This details will help.
Thanks.



No comments:

Post a Comment