Supercharger replacing for Chrysler crossfire.
The complete step by step procedure is as follows:--
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
The complete step by step procedure is as follows:--
Removal & Installation
- Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
- Drain the cooling system.
- Remove or disconnect the following:
Engine coverAir cleaner housingAccessory drive beltThrottle body harness connectorVacuum line at the throttle bodyIntake manifold plenumsSupercharger outlet tube - Release the fuel pressure through the service valve.
Fuel supply line at the fuel railFuel injector harness connectorsFuel rail retaining bolts and remove the fuel railCharge air cooler coolant hoses at the right front of the engineSupercharger clutch harness connectorSecondary air injection valvesSupercharger to cylinder head bolts and remove the supercharger - Remove the old supercharger gaskets
To install:
- Clean and inspect the gasket mating surfaces.
- Install new supercharger gaskets onto the cylinder heads.
- Be sure that the holes in the gaskets are facing toward the front of the engine.
- Install or connect the following:
Supercharger onto the cylinder heads and tighten the bolts to 17 ft. lbs. (23 Nm) in a crisscross patternSecondary air injection valves and tighten the retaining bolts to 17 ft. lbs. (23 Nm)Supercharger harness connectorsCharge air cooler coolant hoses at the right front of the engineFuel rail and tighten the retaining bolts to 80 inch lbs. (9 Nm)Fuel injection harness connectorsFuel supply line at the fuel railSupercharger outlet tubeIntake manifold plenumsVacuum line at the throttle bodyThrottle body harness connectorAccessory drive beltAir cleaner housingEngine cover - Refill the cooling system.
- Connect the negative battery cable.
These details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment