Replace Cylinder head on 3.0L Engine?

The complete Procedure to replace Cylinder head with diagram and Torque Specs.

Please Note that this Procedure Covers all U.S. and Canadian models of the Chrysler/Dodge Avenger, Chrysler Sebring Coupe and Dodge Stratus/ Stratus Coupe models for Year 1999 to 2005.

The cylinder head replacing on 3.0L Engine models.

1. Relieve the fuel system pressure.
2. Drain the cooling system.
3. Remove or disconnect the following:
   
   
   Negative battery cable

   Timing belt

   Alternator

   Intake manifold

   Exhaust manifold

   Water inlet pipe

   Breather and blow by hoses

   Positive Crankcase Ventilation (PCV) hose

   Spark plug cables

   Rocker arm cover

   Timing belt rear cover

   Cylinder head and discard the gasket

To install:

Fig. Cylinder head bolt torque sequence-3.0L engine

1. Clean all mating surfaces of any residual gasket material.
2. Lubricate the threads of the cylinder head bolts with clean engine oil.
3. Install or connect the following:
   
   
   Cylinder head with a new gasket
4. Torque the bolts, in sequence, as follows:
   1. Step 1: 80 ft. lbs. (108 Nm).
   2. Step 2: Loosen all bolts in sequence.
   3. Step 3: 80 ft. lbs. (108 Nm).
5. Install or connect the following:
   
   
   Rear timing belt cover

   Rocker arm cover

   Spark plug cables

   PCV and blow by hoses

   Breather hose

   Water inlet pipe

   Exhaust manifold

   Intake manifold

   Alternator

   Timing belt

   Negative battery cable
6. Fill the cooling system to the proper level.
7. Start the vehicle, check for leaks and repair if necessary.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html