BannerFans.com

Tuesday, April 10, 2012

Mode Door Actuator Removal for Chevy Malibu?

In this chapter details are provided for Mode Door Actuator replacing.
Chevrolet Malibu mode door actuator replacing procedure.

The details are as follows:----

  1. Remove the fuse labeled HVAC CTRL (BATT).
  2. Completely open Instrument Panel (I/P) compartment door (Glove box) by pressing both tabs that support the stop bumpers.

    Click image to see an enlarged view
    Fig. Instrument Panel (I/P) compartment door
  3. Remove the mode actuator screws
  4. Remove the mode actuator 

    image
    Fig. Mode actuator removal
To install:
  1. Install the mode actuator.
  2. Install the mode actuator screws and tighten to 13 inch. lbs. (1.5 Nm).
  3. Install the mode actuator wire harness connector.
  4. Close I/P compartment door (Glove box).
  5. Install the fuse labeled HVAC CTRL (BATT).

These details will help.
Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment