Valve Covers Replacing on Chrysler Crossfire?

The Chrysler Crossfire Valve Covers removing procedure.

The complete step by step info is as follows :---

Magnesium cylinder head covers provide trouble-free sealing, are lighter than aluminum and dampen valve noise. They are cast in two pieces to create internal ventilation passages with oil separators for crankcase vapor ventilation. This ventilation system virtually prevents the possibility of oil sludge formation due to the retention of water vapor in the engine.

Removal & Installation

1. Disconnect battery negative cable from battery and properly isolate to prevent accidental reconnection.
2. Remove or disconnect the following: 
   
   
   Air cleaner housing

   Ignition coil harness connectors

   Spark plug wires at the spark plugs

   Vacuum hoses at the cylinder head cover retainers

   Crankcase ventilation hose from the left cylinder head cover

   Cylinder head cover bolts and the cylinder head covers 
   
   
   

   Fig. Cylinder head cover (2) and bolt (1) overview

To install:

1. Check the gasket for tearing and breakage and replace if necessary.
2. Position the cylinder head covers on the cylinder head.
3. Install the cylinder head cover bolts and tighten to 7 ft. lbs. (10 Nm).
4. Route the engine vacuum hoses on the cylinder head cover retainers.
5. Install or connect the following:
   
   
   Crankcase ventilator hose to the left cylinder head cover

   Ignition coils

   Spark plug wires

   Air cleaner housing

   Negative battery cable

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html