Control Panel Replacing For GMC,Cadillac & Chevy?

The details provided for Control panel Replacing.The instrument panel control panel removal and Auxiliary control panel removal:---

The Procedure mentioned is for
Cadillac Escalade, GMC Suburban 1500 & 2500,Chevrolet Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006).

INSTRUMENT PANEL CONTROL PANEL REMOVAL:-----


The procedure to replace Control Panel is as follows:------

1. Remove the instrument cluster trim plate bezel.
2. Remove the instrument panel storage tray.
3. Remove the accessory switch assembly from the instrument panel.
4. Remove the screws from the HVAC control assembly.
5. Remove the HVAC control assembly, with the following procedure:
   1. Release the retaining tabs.
   2. Pull the control head out of the instrument panel carrier.
6. Unplug the electrical connectors from the HVAC control assembly. 
   
   
   
   Fig. Exploded view of the control panel mounting-2007 models

To install:

WARNING

Make sure the ignition key is in the OFF position when connecting the electrical connectors to ensure the proper calibration of the control panel.

1. Engage the electrical connectors to the HVAC control assembly.
2. Install the HVAC control assembly.
3. Install the accessory switch assembly to the instrument panel.
4. Install the screws from the HVAC control assembly.
5. Install the instrument panel storage tray.
6. Install the instrument cluster trim plate bezel.
   
   WARNING

   Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.
7. Start the vehicle and let run for one minute .

Auxiliary control panel removal:---

1. Separate the front of the console from the headliner.
2. Remove the control assembly by releasing the tabs at the rear of the control.
3. Push the assembly rearward and pull down in order to access the retaining tabs.
4. Disconnect the electrical connector. 
   
   
   
   Fig. Rear auxiliary control-heater and A/C
   
   
   
   
   Fig. Rear auxiliary control-A/C only
5. Connect the electrical connector.
6. Install the control assembly to the console.
7. Install the console to the headliner.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html