How to replace Blend Door Actuator on Chrysler Pacifica?

In this chapter details are provided to replace blend door actuator on Chrysler Pacifica.

The details with step by step instructions are as follows:---

CAUTION

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.

NOTE

The dual zone system has two blend door actuators, one for the driver side blend-air door and one for the passenger side blend-air door.

1. Disconnect and isolate the negative battery cable.
2. Remove the silencer from beneath the driver side of the instrument panel.
3. Disconnect the wire harness connector from the blend door actuator being serviced.
4. Remove the two screws that secure the blend door actuator being serviced to the HVAC air distribution housing and remove the actuator. 
   
   
   
   Fig. Blend door actuator and components

To install:

1. Position the blend door actuator being serviced onto the HVAC air distribution housing. If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those in the blend air door linkage.
2. Install the two screws that secure the blend door actuator to the air distribution housing. Tighten the screws to 17 inch lbs. (2 Nm).
3. Connect the wire harness connector to the blend door actuator being serviced.
4. Install the silencer beneath the driver side end of the instrument panel.
5. Reconnect the negative battery cable.
6. Calibrate the A/C-heater control.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html