G5 Control Panel Removal?

Please note the details mentioned here Covers All U.S. And Canadian Models Of Chevrolet Cobalt and Pontiac G5  car models.

In this chapter the HVAC control panel removal procedure is mentioned.
The details are as follows:-----

1. Remove the Instrument Panel (I/P) center trim panel (1) by pulling out on the trim panel in order to release the retaining fasteners (2).
2. Disconnect the electrical connectors on the Instrument Panel (I/P) center trim panel (1). 
   
   
   
   Fig. Remove the HVAC control panel (module) assembly
3. Remove the HVAC control panel screws.
4. Remove the HVAC control panel (module) assembly.
   
   NOTE

   The HVAC control connector and the radio connector can be interchanged by mistake. Mark or place tape on the connector to avoid accidental interchange.
5. Disconnect the HVAC control panel assembly electrical connectors.

Fig. Remove the Instrument Panel (I/P) center trim panel by releasing the retaining fasteners

To install:

1. Connect the HVAC control panel assembly electrical connectors.
2. Install the HVAC control panel (module) assembly.
3. Install the HVAC control panel screws. Tighten the screws to 19 inch lbs. (2 Nm).
4. Connect the electrical connectors on the I/P center trim panel (1).
5. Install the I/P center trim panel (1) by pressing in on the trim panel in order to attach the retaining fasteners (2).

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html