The procedure mentioned here is for Above mentioned car models:----
Cadillac Escalade, GMC Suburban 1500 & 2500, Chevrolet Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006).
Blower motor Removal & Installation For
Auxiliary blower motor Procedure
DELPHI BLOWER MOTOR Procedure
VISTEON BLOWER MOTOR Procedure
The details are as follows:----
Auxiliary blower motor replacing Procedure:----
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
Cadillac Escalade, GMC Suburban 1500 & 2500, Chevrolet Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006).
Blower motor Removal & Installation For
Auxiliary blower motor Procedure
DELPHI BLOWER MOTOR Procedure
VISTEON BLOWER MOTOR Procedure
The details are as follows:----
Auxiliary blower motor replacing Procedure:----
- Remove the right rear quarter trim panel.
- Disconnect the electrical connectors.
- Remove the blower motor screws.
- Remove the blower motor from the auxiliary HVAC module.
- Remove the retaining clip from the fan cage.
- Remove the fan cage from the blower motor.
Fig. Auxiliary blower motor removal
To install:
- Install the fan cage to the blower motor.
- Install the retaining clip to the fan cage.
- Install the blower motor to the auxiliary HVAC module.
- Install the blower motor screws.
- Connect the electrical connectors.
- Install the right rear quarter trim.
Delphi Blower Motor
- If equipped, remove the sound insulator panel.
- Remove the blower motor insulating cover screws.
- Disconnect the electrical connector from the blower motor.
- Remove the blower motor insulating cover.
- Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/ventilation module.
- Remove the blower motor.
To install:
- Install the blower motor.
- Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
- Install the blower motor insulating cover.
- Connect the electrical connector to the blower motor.
- Install the blower motor insulating cover screws.
- Tighten the screws to 14 inch lbs. (1.6 Nm).
- If equipped, install the sound insulator panel.
Visteon Blower Motor
- Remove the sound insulator panel.
- Disconnect the electrical connector from the blower motor.
- Remove the screws from the blower motor.
- Remove the blower motor from the HVAC module.
- Remove the retainer from the blower motor wheel. Discard the retainer.
- Remove the blower motor wheel from the blower motor.
To install:
- Install the blower motor wheel to the blower motor.
- Install the New retainer to the blower motor wheel.
- Install the blower motor to the HVAC module.
- Install the screws to the blower motor.
- Tighten the screws to 18 inch lbs. (2 Nm).
- Connect the electrical connector to the blower motor.
- Install the sound insulator panel.
These details will help.
Thanks.
FOR MORE HELP GO TO: ---
No comments:
Post a Comment